Chapter 1 — Using the CK30 Handheld Computer
22 CK30 Handheld Computer User’s Manual
Changing the Beeper Volume
Method Procedure
Use the keypad.
Press C and then press E to increase the
volume. There are five beep volumes on the
CK30 including off. When you reach the
loudest setting, the next setting is off. The
volume starts with the lowest setting and goes
up.
Use the Intermec
Configuration
menu.
From the System Main Menu, choose
Configuration Utility > Device Settings >
Beeper > Volume.
Use the Beeper
Volume command.
For help, see “Beeper Volume” in the Intermec
Computer Command Reference Manual.
Scanning Bar Codes
Do not look directly into the window area or at a reflection
of the laser beam while the laser is scanning. Long-term
exposure to the laser beam can damage your vision.
Use the scanner to scan and enter bar code data. The type of
scanner you are using and the type of bar code you are decoding
determines the way you scan the bar code. The CK30 supports
the scanning of 1D linear bar codes. Plus, if you are using an
integrated handle or a tethered scanner, the way you scan bar
codes is different.
When you unpack the CK30, these bar code symbologies are
enabled:
• Code 39
• Code 128
• Datamatrix (if supported)
• PDF417
• UPC/EAN
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on the computer.
Use the Configuration Utility to enable and disable symbologies
To Next Page
Loading...
