Chapter 1 — Using the CK30 Handheld Computer
CK30 Handheld Computer User’s Manual 25
You may need to continue moving the beam from the bottom
of the bar code label to the top, and back to the bottom, until
you hear the high beep.
6 Release the Scan button.
Attaching a Tethered Scanner
You can use a tethered scanner with the CK30 if you ordered it
with a 10-pin tethered scanner port in place of the integrated
scanner. The following devices have been supported by the
CK30:
Supported Device Required Cable
1550C0100*, 1550C0102*, 1550C0104*,
and 1550C0105*
068419-001*
1551E* 3-606034-02*
1553* 3-606034-02*
128X wands* 069444-002*
ASCII (generic decoded-output scanner) 3-606034-02*
* These products are not RoHS compliant and are discontinued. This
information is included here only for customers who have already
purchased these products.
To attach a tethered scanner
1 Locate and remove the scanner port cover.
Scanner
port cover
2 Insert the scanner 10-pin connector until it locks in place.
To Next Page
Loading...
