Intermec CK30

Chapter 2 — Configuring the CK30
CK30 Handheld Computer User’s Manual 67
2 Make sure you have configured the communications and
radio parameters on your CK30.
3 Choose Configuration Utility > Communications > 802.11
Radio > Funk Security > Profile.
4 For 8021x, choose LEAP and then press Enter.
5 For Association, choose Open, WPA, WPA2, or Network
EAP and then press Enter. Encryption automatically defaults
to TKIP if you choose WPA, to AES if you choose WPA2,
and to WEP if you choose Open or Network EAP.
6 Select Prompt for Credentials, choose Enter credentials
now, and then press Enter.
7 Select User name, type your user name, and then press
Enter.
8 Select User Password, type a user password, and then press
Enter.
9 Exit the Configuration Utility.
Configuring Static WEP Security
The CK30 uses the Wired Equivalent Privacy (WEP) protocol
to add security to your wireless network based on the 802.11b
standard.
To use WEP security, you need:
• a CK30 handheld computer with an 802.11b/g radio.
• an access point with an 802.11b/g radio.
Configuring Static WEP Security With Funk Security
1 Make sure you have selected Funk as your security choice.
2 Make sure you have configured the communications and
radio parameters on your CK30.
3 Press C and then B to open the System Main Menu.
4 Choose Configuration Utility > Communications > 802.11
Radio > Funk Security > Profile.
5 For Association, choose Open and then press Enter.
6 For Encryption, choose WEP and then press Enter.