Chapter 5 — Running Diagnostics
112 CK30 Handheld Computer User’s Manual
To close the CPU Monitor diagnostic
1 Go to Diagnostics > System Diagnostics > CPU Monitor.
A dialog box appears asking if you want to stop the CPU
Monitor.
2 Press Enter.
Display Test
Use the Display Test to make sure that every pixel on the CK30
screen is working correctly. For example, you may want to test
the screen if you do not see complete characters on the screen.
The Display Test turns all pixels on, displays horizontal stripes,
displays vertical stripes, and then turns all pixels off. If you have
a color screen, the display test also changes your screen to blue,
red, and then green.
To open the Display Test diagnostic
• Go to Diagnostics > Hardware Diagnostics > Display Test.
Sample Screen
Hardware Configuration Table
Use the HW Config Table to view important information about
your CK30 such as the serial number, configuration number,
model, software options, and the scanner type.
You can use this information to tell the Intermec representative
information on the hardware and software that were installed at
the Intermec factory.
To Next Page
Loading...
