Chapter 2 — Configuring the CK30
52 CK30 Handheld Computer User’s Manual
Ethernet
CK30A
CK30A CK30A
Host
Older CK30s in an Ethernet Network
To use an older CK30 in an Ethernet network
1 Configure these network parameters on each CK30:
• If you have a DHCP server, enable DHCP.
• If you do not have a DHCP server, set these parameters:
a IP address
b Subnet mask
c Default router
2 If required for your network, you may also need to set these
parameters on each CK30:
• Primary and secondary DNS Servers
• Primary and Secondary WINS Servers
3 Make sure that your CK30 is talking to the network and that
the network can see your CK30.
To Next Page
Loading...
