Intermec CK30

Chapter 6 — Troubleshooting and Maintaining the CK30
134 CK30 Handheld Computer User’s Manual
Problems While Scanning Bar Codes (continued)
Problem Solution
Your 1551E or 1553 scanner
stopped working after you activated
energy saver mode or connected a
cable.
You can enable energy saver mode only if the
scanner is connected to the CK30 by an energy
saving cable.
Follow these steps:
1 Disconnect the scanner from the CK30.
2 Find the Reset Factory Defaults bar code in
the scanner documentation.
3 While pulling the trigger, hold the scanner
over the Reset Factory Defaults bar code, and
apply external power to the scanner. The
scanner is reset to factory defaults.
4 Use Configuration Utility or Intermec Settings
to disable energy saver mode on the CK30.
5 Use Configuration Utility or Intermec Settings
to disable the port on the CK30.
6 Attach the scanner to the CK30.
7 Use Configuration Utility or Intermec Settings
to enable the port.
8 Use the scanner to scan a bar code. The
scanner should work now, but energy saver
mode is disabled.
Continue with Steps 9 through 11 only if you
want to use energy saver mode.
9 Install the correct energy saving cable. Use
P/N 3-606034-02 for the 10-pin scanner port,
or use P/N 3-606032-03 for the serial port.
10 Use Configuration Utility or Intermec Settings
to enable energy saver mode on the CK30.
11 Use the scanner to scan a bar code. Energy
saver mode is enabled.