Intermec CK30

Chapter 2 — Configuring the CK30
CK30 Handheld Computer User’s Manual 59
To configure WPA-802.1x or WPA2-802.1x with Funk security
1 Make sure you have configured the communications and
radio parameters on your CK30.
2 Make sure you have selected Funk as your security choice.
3 Press C and then B to open the System Main Menu.
4 Choose Configuration Utility > Communications > 802.11
Radio > Funk Security > Profile.
5 For Association, choose WPA or WPA2 and press Enter.
Encryption automatically defaults to TKIP if you are using
WPA. Encryption automatically defaults to AES if you are
using WPA2.
6 For 8021x, choose TTLS, PEAP, or TLS and press Enter.
If you choose TTLS or PEAP:
a Select Prompt for Credentials, choose Enter credentials
now and press Enter.
Note: You can use Prompt for credentials to troubleshoot
your connection to the network if you have problems.
b Select User Name, type a user name, and then press Enter.
c Select User Password, type a user password, and then
press Enter.
d Select Validate Server Certificate, choose Yes, and then
press Enter.
Note: You must have the date on the CK30 set correctly
when you enable Validate Server Certificate.
If you choose TLS:
a Load a user and root certificate on your CK30. For help,
see “Loading a Certificate” on page 69 for help.
b Select Validate Server Certificate, choose Yes, and then
press Enter.
c You must enter a User Name and Subject Name. You can
also enter a Server Common Name if you want to increase
your level of security.