Intermec CK30

Chapter 2 — Configuring the CK30
64 CK30 Handheld Computer User’s Manual
Note: You can use Prompt for credentials to troubleshoot
your connection to the network if you have problems.
b Select User Name, type a user name, and then press Enter.
c Select User Password, type a user password, and then
press Enter.
d Select Validate Server Certificate, choose Yes, and then
press Enter.
Note: You must have the date on the CK30 set correctly
when you enable Validate Server Certificate.
If you choose TLS:
a Load a user and root certificate on your CK30. For help,
see “Loading a Certificate” on page 69 for help.
b Select Validate Server Certificate, choose Yes, and then
press Enter.
c You must enter a User Name and Subject Name. You can
also enter a Server Common Name if you want to increase
your level of security.
8 Exit the Configuration Utility.
Configuring 802.1X Security With Microsoft Security
Use this procedure to configure 802.1x security on your CK30
with Microsoft security.
To enable 802.1x security on your CK30
1 Make sure you have configured the communications and
radio parameters on your CK30.
2 Press C and then B to open the System Main Menu.
3 Choose Configuration Utility > Communications > 802.11
Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose Open.
6 For Data Encryption, choose WEP.