Intermec EasyCoder PC4 Service Manual

Intermec EasyCoder PC4—Service Manual v
Preface
About This Manual
is Service Manual is intended to facilitate installation, troubleshooting
and repair of the Intermec EasyCoder PC4 in the version delivered at the
date of publishing. us, all information on the ESim firmware is based on
version 6.xx. e on-going product improvement can be followed in the
Technical Bulletins published at the Intermec Knowledge Center.
is Service Manual is supplemented by the following publications, which
the service technician also should keep easily available in their latest ver
-
sions:
• Intermec EasyCoder PC4, Quick Start Guide (multilingual)
• Intermec EasyCoder PC4, User’s Guide
• Intermec EasyCoder PC4, Spare Parts Catalog
• ESim v6.xx, Programmer’s Reference Manual
Please note that the operations described in this manual only should be car
-
ried out by skilled and authorized personnel with proper training and full
understanding of written English. Moving parts may cause harm, if incor
-
rectly manipulated.
It is assumed that the reader possesses adequate skills in mechanics and
electronics and is familiar with the ESim protocol and its related standard
application programs. It is also assumed that the reader has access to the
standard tools of an electronics workshop.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing