Intermec EasyLAN 10I2 User Manual

Configuring the EasyLAN 10i2 Adapter
2-5
2
Configure TCP/IP Page
2. Configure the parameters. For information on the parameters, see “TCP/IP
Parameters Defined” later in this section.
3. Click Submit. A page appears letting you know that your changes were successful.
4. Click OK to return to the Configuration and Management page.
You can now communicate with your EasyLAN 10i2 adapter using TCP/IP or configure
other settings.
TCP/IP Parameters Defined
Parameter Definition Values
TCP/IP Enable or disable TCP/IP communications. Enable, Disable
Default = Enable
Enabled services Configure the services on the port you are using. For help, see
“Configuring the Port Services” later in this chapter.
IP address Enter the IP address for the EasyLAN 10i2 adapter. After you click
Submit in the Web browser interface, you will have to enter the new
IP address in the Address/Go to line of your browser to get the Web
browser interface back.
n.n.n.n
where
n
is
from 0 to 255
Default = 0.0.0.0
Subnet mask Enter the subnet mask.
n.n.n.n
where
n
is
from 0 to 255
Default = 0.0.0.0

Intermec EasyLAN 10I2 Specifications

General

Brand	Intermec
Model	EasyLAN 10I2
Category	Adapter
Language	English