Chapter 1 — Learning About the SR61
SR61 Cordless Scanner User’s Guide 3
Using the Battery
The SR61 uses the AB3 lithium-ion battery as its main power
source. You need to fully charge the battery before you can use
the SR61.
Charging the Battery
Make sure you fully charge the battery before you start using the
SR61.
To charge the battery
• Place the SR61 with the AB3 battery installed in the desktop/
wall mount 1-bay charger (AC5).
Or,
• Remove the battery from the SR61, and insert the battery
into the 2-bay, 4-bay, or 8-bay (AC6, AC7, or AC8) charger.
For more information, see the instructions that ship with the
charger.
Checking the Battery Status
You can check your battery status at any time.
To check the battery status
• Pull the trigger.
If the status light on the SR61 turns red, the battery is low
(less than 20% battery capacity remaining). You need to
charge the battery now.
The battery pack used in this device may ignite, create a chemical
burn hazard, explode, or release toxic materials if mistreated. Do not
incinerate, disassemble, or heat above 100°C (212°F). Charge only
with Intermec Models AC5, AC6, AC7, and AC8. Do not short
circuit; may cause burns. Keep away from children.
Use only Intermec battery pack Model AB3. Use of incorrect battery
pack may present risk of fire or explosion. Promptly dispose of used
battery pack according to the instructions.
To Next Page
Loading...
