Chapter 4 — Configuration Command Reference
SR61 Cordless Scanner User’s Guide 39
SR61 Configuration Commands
This section lists the configuration commands in alphabetical
order and provides a description of each command. To configure
your SR61 using these commands, see the EasySet software.
Administrator Reset Factory Defaults
Causes the SR61 to perform a restart and restores all
configuration commands to their default settings, including the
Bluetooth PIN. When you restore all configuration commands to
their default settings, you need to reestablish Bluetooth
communications.
Aimer Flashing Mode
SR61xA (area imager) only. By default, the SR61 aimer beam
flashes repeatedly while the imager is trying to read a bar code.
The aimer beam flashes on so that you can see where to aim the
SR61, and it flashes off to read the bar code with the least
amount of interference from the light of the aimer beam. You can
change this default setting so that the aimer is always on.
Australian Post
SR61xA (area imager) only. Enables or disables decoding of
AustraliaPost symbology. AustraliaPost is a 4-state bar code that
allows Australia Post to sort incoming mail using a bar code read
from letters. There are three different types of bar codes
corresponding respectively to FCC values 11, 59 and 62.
BarDIMM only needs the DPID and Customer information,
and automatically generates all the other information like the
FCC or Reed-Solomon checksum.
Aztec
SR61xA (area imager) only. Enables or disables decoding of Aztec
symbology. Aztec is a 2D matrix symbology made up of square
modules on a square grid, with a square bullseye pattern at their
center. Aztec Code symbols can encode large amounts of data
with user-defined error-correction level.
To Next Page
Loading...
