Intermec SR61 - Configuring the SR61 Parameters

Chapter 2 — Connecting and Configuring the SR61
SR61 Cordless Scanner User’s Guide 19
To configure the SR61 by scanning bar codes
1 Start EasySet. The first time you start EasySet, the Select
product dialog box appears.
If the Select product dialog box does not appear, choose
Product > Select.
2 Select the SR61.
3 In the Commands window, choose configuration command
settings for your SR61 and add them to the bar code setup
sheet.
4 Scan the bar codes onscreen with your SR61xA or SR61xV, o r
print the setup sheet and scan the commands. When you scan
bar code configuration commands, the SR61 emits a series of
beeps unless the volume is turned off.
• One beep means you scanned a valid configuration
command.
• Three beeps means you scanned an invalid configuration
command.
For more information about EasySet, see the EasySet software.
For descriptions of the configuration commands, see Chapter 4,
“Configuration Command Reference.”
Configuring the SR61 From Your Intermec Computer
You can configure many settings for the SR61 from your
Intermec computer. For descriptions of the configuration
commands, see Chapter 4, “Configuration Command
Reference.”
To configure the SR61 from your Intermec computer
1 Establish a Bluetooth connection with your Intermec
computer.
2 On your Intermec computer, start the Intermec Settings
application.
Note: When you connect to an Intermec computer, all SR61
settings that are common to the Intermec computer’s internal
scanner settings are changed to the default settings for the
internal scanner.