Chapter 2 — Connecting and Configuring the SR61
20 SR61 Cordless Scanner User’s Guide
3 Select Data Collection > SR61 Scanner Bluetooth Address,
where Bluetooth Address is the Bluetooth address of your
SR61.
4 Configure commands from the SR61 Scanner menu for your
SR61.
5 Select File > Save Settings. The SR61 is updated with the
new configuration command settings.
6 Close Intermec Settings.
Restoring Default Settings
You can restore the SR61 to its default settings by scanning the
Administrator Reset Factory Defaults command. For a list of the
default settings, see “Configuration Commands By Function”
on page 35.
To restore default settings
•Scan this bar code:
Administrator Reset Factory Defaults
\60\08\55\22
Note: Using the Administrator Reset Factory Defaults command
resets all parameters. As a result, you will lose Bluetooth
communications.
After you scan the Administrator Reset Factory Defaults
command, the SR61 produces a continuous tone while the
non-volatile memory is being written. Do not remove the
battery or place the SR61 in a 1-bay charger until the tone
stops. The firmware memory may be corrupted.
To Next Page
Loading...
