Intermec SR61 - Connecting and Configuring the SR61

Chapter 2 — Connecting and Configuring the SR61
SR61 Cordless Scanner User’s Guide 13
Connecting to an Intermec Computer
1 On your PC, start EasySet. Make sure that SR61 is selected as
your product.
2 From the EasySet commands window, select Data
transmission settings > Bluetooth Parameters > connect/
disconnect.
3 Double-click compose BT address.
4 Enter the Bluetooth address of your Intermec computer and
click OK. The bar code appears on the setup sheet.
5 Scan the bar code onscreen with the SR61xA or SR61xV, o r
print the bar code setup sheet and scan the bar code.
The SR61 beeps once, the green status light flashes once, and
the blue Intermec Ready-to-Work™ indicator starts blinking.
On your Intermec computer, the Authen. Request dialog box
appears.
6 In the Enter PIN field, enter the default PIN (0000) and
select OK.
When the SR61 connects to your Intermec computer, the
SR61 emits a series of beeps from low to high, and the blue
Intermec Ready-to-Work indicator turns on and stays on. The
SR61 is ready to scan data.
Note: When you connect to an Intermec computer, all SR61
settings that are common to the Intermec computer’s internal
scanner settings are changed to the default settings of the internal
scanner.
Note: To connect more than one SR61 to your Intermec
computer, use the Bluetooth Device Utility or the Bluetooth
control panel on the Intermec computer. For help, see the
documentation for your Intermec computer.