Chapter 4 — Configuration Command Reference
SR61 Cordless Scanner User’s Guide 45
Consecutive Same Read Data Validation
To increase decode security, you can have the scanner scan a bar
code multiple times to ensure you have a valid read before
transmitting the data.
You can set Consecutive Same Read Data Validation from 0 to
10. The default value of 0 sets the scanner to automatically adapt
the consecutive same read based on the bar code quality and the
trust level of the bar code. For example, labels with a check digit
require less reads than labels without a check digit.
Data Editing
Data editing allows you to edit data scanned by the SR61 before
it is transmitted to your host. You can define up to seven input
scenarios to filter out the data you want to edit. For more
information, see the EasySet software.
DataMatrix
SR61xA (area imager) only. Enables or disables decoding of
DataMatrix symbology. DataMatrix is a high density 2D matrix
code that can store a large amount of information. It has excellent
error correction abilities and is mostly used for marking and
tracking parts.
Decode Mode
SR61xA (area imager) only. Sets the imager decode mode to
linear imager emulation (1D) or 2D imager mode.
2D imager mode allows you to hold the SR61xA in any
direction, regardless of the orientation of the bar code, and
perform a good read. The ability to read bar codes in any
direction lets you use a comfortable and ergonomic hand
position.
Linear imager emulation allows you to increase your imaging
performance (similar to a laser scanner), but you need to hold the
SR61xA horizontal to the 1D bar code label.
To Next Page
Loading...
