Chapter 4 — Configuration Command Reference
SR61 Cordless Scanner User’s Guide 55
User Reset Factory Defaults
Causes the SR61 to perform a restart and restores all
configuration commands to their default settings, only if no
settings are locked. To reset all settings on the SR61, including
locked settings, use the Administrator Reset Factory Defaults
command. For more information, see “Administrator Reset
Factory Defaults” on page 39.
When you restore all configuration commands to their default
settings, you need to reestablish Bluetooth communications.
Vibrate Alert
Enables or disables the vibrate alert. When Vibrate Alert is
enabled, the scanner vibrates when you scan a valid bar code.
Vibrate Alert Duration
Sets the amount of time that the vibrate alert remains on. You can
set Vibrate Alert Duration to a value from 0 to 2550 ms.
To Next Page
Loading...
