Intermec SR61 - Using Vibrate Alert

Chapter 1 — Learning About the SR61
SR61 Cordless Scanner User’s Guide 9
To scan a bar code label with the 2D area imager
1 Point the scanner window at the bar code label and hold the
SR61 steady a few inches from the label.
2 Pull the trigger and center the red aiming beam over the bar
code label.
3 The imager flashes repeatedly while it is trying to read a bar
code. The aiming beam is smaller when the imager is closer to
the bar code and larger when it is further away.
When the SR61 successfully reads a bar code label, you hear a
single high beep and the status light briefly turns green. If
Vibrate Alert is enabled, the SR61 briefly vibrates.
4 Release the trigger.
Using Vibrate Alert
You can configure the SR61 to vibrate when it successfully
decodes a bar code. This feature can be useful in these situations:
• You are in a noisy environment, such as a busy warehouse,
where it can be difficult to hear the beep.
• You are working in a quiet environment, such as a library,
where you do not want to make a lot of noise.
To turn on vibrate alert
•Scan this bar code:
Turn On Vibrate Alert
\60\03\10\48\00\02\40
To turn off vibrate alert
•Scan this bar code:
Turn Off Vibrate Alert
\60\03\10\48\00\00\00