Chapter 1 — Learning About the SR61
6 SR61 Cordless Scanner User’s Guide
You can change the beep volume for your needs and
environment. You can set the beep volume to Low (quiet),
Medium (loud), or High (very loud - default).
To turn off the beeper
•Scan this bar code:
Beep Duration - 0
\60\03\11\21\00\00\00
SR61 Beeps Description
Beep Sequence What It Means
Single beep The SR61 successfully decoded a bar code or
scanned a configuration bar code.
Series of beeps from
low to high
The SR61 connected to a Bluetooth host.
Series of beeps from
high to low
A Bluetooth connection has been lost.
Three beeps Data was not successfully sent to the host. The
SR61 is out of range of the host.
A configuration bar code was not successfully
scanned.
Continuous tone for
several seconds
You just scanned the Administrator Reset
Factory Defaults bar code and the non-volatile
memory is being written.
Do not remove the battery or place the SR61
in a 1-bay charger until the tone stops. The
firmware memory may be corrupted.
Continuous beeping
for 1 minute
The host PC is paging the SR61. Once you
find the SR61, pull the trigger to stop the
beeps. For more information about paging the
SR61, see “Paging the SR61” on page 29.
Note: Turning off the beeper does not affect the beeps for
Bluetooth Connect/Disconnect or Bluetooth Device Page.
To Next Page
Loading...
