LIST OF FIGURES
Belt Splicing System v.2.0
LOF
SPECIAL PROCEDURES
11 SPECIAL PROCEDURES
Figure 11A: Place the Clamping Fixture on a flat,
stable surface ............................................. 11- 1
Figure 11B: Make a Belt Tab........................ 11- 1
Figure 11C: Apply tape at Deck edge ........... 11- 2
Figure 11D: Trim away excess tape ............. 11- 2
Figure 11E: Replace the belt end.................. 11- 2
Figure 11F: Bend belt back onto Cut Guide... 11- 3
Figure 11G: Open Clamping Fixture.............. 11- 3
Figure 11H: Close Clamping Fixture and
ensure metal pads touch ............................. 11- 3
12 NUB TOP STYLE SPECIFICS
Figure 12A: Nub Top Samples ..................... 12- 1
Figure 12B: Remove nubs from
splicing area ............................................... 12- 1
Figure 12C: Spacers for
42" Clamping Fixture ................................... 12- 1
Figure 12D: Place Cut Guide on
Silicone Spacer........................................... 12- 2
Figure 12E: Align Silicone Spacer with
Deck edge................................................... 12- 2
13 TROUGHING GROOVES SPECIFICS
Figure 13A: Troughing groove samples........ 13- 1
Figure 13B: Center tape at Grooved
Deck edge................................................... 13- 1
Figure 13C: Trim tape width......................... 13- 2
Figure 13D: Trim tape length........................ 13- 2
Figure 13E: Finish belt end alignment........... 13- 2
14 S8126 BELT SPECIFICS
Figure 14A: S8126 Samples........................ 14- 1
Figure 14B: Trim tape at the belt edges ........ 14- 2
Figure 14C: Choose Belt Tabs thinner
than belt...................................................... 14- 2
Figure 14D: Place Belt Tabs on
Grooved Decks ........................................... 14- 2
Figure 14E: Inspect with square edge........... 14- 3
Figure 14F: Clamp belt edges securely......... 14- 3
Figure 14G: Secure the second Cut Guide
in place....................................................... 14- 3
To Next Page
Loading...