LIST OF FIGURES
LOF
Belt Splicing System v.2.0
Figure 5E: Close the Clamping Fixture............ 5- 3
Figure 5F: Align right and left belt edges......... 5- 3
Figure 5G: Secure second belt end ................ 5- 3
Figure 5H: Clamping Fixture closed–but
not locked..................................................... 5- 4
Figure 5I: Inspect for gaps and horizontal
alignment...................................................... 5- 4
Figure 5J: Inspect belt surface vertical
alignment...................................................... 5- 5
6 SPLICE THE BELT
Figure 6A: Clean residue from the
Heat Wand.................................................... 6- 1
Figure 6B: Latch Heat Wand in Stand............. 6- 1
Figure 6C: Remove the Heat Wand from
the Stand ...................................................... 6- 2
Figure 6D: Wand Rest at one end .................. 6- 3
Figure 6E: Close Clamping Fixture on
Heat Wand.................................................... 6- 3
Figure 6F: Remove Heat Wand ...................... 6- 3
Figure 6G: Close Grooved Decks as
Heat Wand is lifted ........................................ 6- 3
Figure 6H: Heat Wand removed and
belt cooling................................................... 6- 3
Figure 6I: Wipe residue from the Heat Wand .. 6- 4
Figure 6J: Small, even weld bead................... 6- 4
7 TRIM & INSPECT THE BELT
Figure 7A: Secure the belt.............................. 7- 1
Figure 7B: Separate the weld bead
from the belt ................................................. 7- 1
Figure 7C: Remove the first weld bead........... 7- 1
Figure 7D: Remove the second weld bead ..... 7- 2
Figure 7E: Trim and skive .............................. 7- 2
Figure 7F: Trim flash from belt edges............. 7- 2
Figure 7G: Trim rough edges or small corners 7- 2
Figure 7H: Create a smooth edge and
discard debris ............................................... 7- 3
Figure 7I: Check pitch at splice ...................... 7- 3
Figure 7J: Inspect for splice faults
(e.g., bubbles shown here)............................ 7- 4
8 SHUT DOWN, COOL, & PACK UP
Figure 8A: Pack main components ................ 8- 1
Figure 8B: Secure the twist latches ................ 8- 2
TROUBLESHOOTING
10 TROUBLESHOOT
To Next Page
Loading...