SECTION 5—SEAT
Solara
™
and Solara
™
Limited 28 Part No 1085787
After determining caster size and caster position needed, refer to Installing/Removing/
Adjusting Caster/Fork on page 44.
After determining rear wheel size, refer to the Owner's Manual, part number 1080556.
WARNING
After changing Seat-to-Floor Height, the anti-tippers MUST be adjusted BEFORE
using the wheelchair. Refer to Installing/Adjusting Anti-tippers
in the Owner's Man-
ual, part number 1080556.
16 INCH SEAT-TO-FLOOR
NOTE: The seat-to-floor heights are based on pneumatic tires and pneumatic tires with flat free
inserts. If wheelchair is equipped with urethane tires, subtract ¼ inch from the measurements listed
above. All heights are measured with properly inflated new tires. These heights can vary ± ¼ inch
due to tire wear.
*NOTE: A 2-inch lower seat-to-floor is obtainable when attaching the seat pan/seating system to
the crossmembers instead of the seat rails.
FORK CASTER REAR WHEEL AXLE PLATE SEAT-TO-FLOOR
6 inch/
Top Hole
6 inch 12 inch Rounded Down/
Bottom 2 Holes
16 inch
*14 inch
To Next Page
Loading...
