INVT Goodrive 35 Series - Page 113

Goodrive35 inverters Function codes
112
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
model
P08.03
DEC time
3
Depend
on
model
○
P08.04
ACC time
4
Depend
on
model
○
P08.05
DEC time
4
Depend
on
model
○
P08.06
Jogging
frequency
This parameter is used to define the reference
frequency during jogging.
Setting range: 0.00Hz ~P00.03
(the Max. frequency)
5.00
Hz
○
P08.07
Jogging
ACC time
The jogging ACC time means the time needed if the
inverter runs from 0Hz to the Max. Frequency.
The jogging DEC time means the time needed if the
inverter goes from the Max. frequency (P0.03) to
0Hz.
Setting range:0.0~3600.0s
Depend
on
model
○
P08.08
Jogging
DEC time
Depend
on
model
○
P08.09
Jumping
frequency
1
When the set frequency is in the range of jumping
frequency, the inverter will run at the edge of the
jumping frequency.
The inverter can avoid the mechanical resonance
point by setting the jumping frequency. The inverter
can set three jumping frequency. But this function
will be invalid if all jumping points are 0.
0.00
Hz
○
P08.10
Jumping
frequency
range 1
0.00
Hz
○
P08.11
Jumping
frequency
2
0.00
Hz
○
P08.12
Jumping
0.00
○
www.barghmaher.ir