0x0000~0xFFFF
Bit0: Spindle position enabled
0:Disabled 1: Enabled
Bit1: Zero position selection
0: Z pulse input 1: Terminal input
Bit2: Zero position search
0:search once 1: search every time
Bit3: Correction enable of the reference point
0: Disabled 1: Enabled
Bit4: Position mode 1
0: Position at the set direction
1: Position at the nearest direction
Bit5: Position mode 2
0: Forward position 1: Reverse position
Bit6: Zeroing correction
0: Electric level 1:Pulse
Bit7: Correction mode
0: First correction 1: Current correction
Bit8: Reserved
Bit9:signal selection
0:Electric level signal
1:Pulse signal
Bit10:Z pulse source
0:from the motor
1:from the spindle
Bit11~15:Reserved
Search the speed at the stopping start point and after
finding out the stopping start position, switch to
stopping position control
0.00~100.00Hz
To Next Page
Loading...
