INVT Goodrive 35 Series - Page 67

Goodrive35 inverters Function codes
66
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
Setting range of P01.09: 0.00Hz~P00.03
Setting range of P01.10: 0.00~30.00s
Setting range of P01.11: 0.0~100.0%
Setting range of P01.12: 0.0~50.0s
P01.13
Dead time
of
FWD/REV
rotation
During the procedure of switching for/rev rotation,
set the threshold by P01.14, which is as the table
below:
Setting range: 0.0~3600.0s
0.0s
○
P01.14
Shifting
between
FWD/REV
rotation
Set the threshold point of the inverter:
0:Switch after zero frequency
1:Switch after the starting frequency
0
◎
P01.15
Stopping
speed
0.00~100.00Hz
0.20
Hz
◎
P01.16
Detection
of stopping
speed
0: Detect according to speed setting (no stopping
delay)
1: Detect according to speed feedback (only valid for
vector control)
0
◎
www.barghmaher.ir