INVT Goodrive270 Series

Goodrive270 series VFD for fan and pump Communication protocol
-304-
Table 9-1 Addresses of other function parameters
Function
Address
Data description
R/W
Communication-based
control command
2000H
0001H: Run forward
R/W
0002H: Run reversely
0003H: Jog forward
0004H: Jog reversely
0005H: Stop
0006H: Coast to stop
0007H: Fault reset
0008H: Stop jogging
Communication-based
setting address
2001H
Communication-based frequency setting (0–Fmax;
unit: 0.01 Hz)
R/W
2002H
PID reference (0–1000, in which 1000 corresponds
to 100.0%)
2003H
PID feedback (0–1000, in which 1000 corresponds
to 100.0%)
R/W
2004H
Torque setting (-3000–3000, in which 1000
corresponds to 100.0% of the motor rated current)
R/W
2005H
Upper limit setting of forward running frequency
(0–Fmax; unit: 0.01 Hz)
R/W
2006H
Upper limit setting of reverse running frequency
(0–Fmax; unit: 0.01 Hz)
R/W
2007H
Electromotive torque upper limit (0–3000, in which
1000 corresponds to 100.0% of the motor rated
current)
R/W
2008H
Braking torque upper limit. (0–3000, in which 1000
corresponds to 100.0% of the VFD rated current)
R/W
2009H
Special CW
Bit0–1=00: Motor 1 =01: Motor 2
Bit2=1 Enable speed/torque control switchover
=0: Disable speed/torque control switchover
Bit3=1 Clear electricity consumption data
=0: Keep electricity consumption data
Bit4=1 Enable pre-excitation =0: Disable
pre-excitation
Bit5=1 Enable DC braking =0: Disable DC braking
R/W
200AH
Virtual input terminal command (0x000–0x3FF)
(Corresponding to
S8/S7/S6/S5/Reserved/HDIA/S4/ S3/ S2/S1)
R/W