INVT Goodrive270 Series

Goodrive270 series VFD for fan and pump Function parameter list
-192-
Function
code
Name
Description
Default
Modify
P06.33
Detection value for
frequency being
reached
0–P00.03
1.00Hz
○
P06.34
Frequency reaching
detection time
0–3600.0s
0.5s
○
P07 group––Human-machine interface
Function
code
Name
Description
Default
Modify
P07.00
User password
0–65535
When you set the function code to a non-zero
number, password protection is enabled.
If you set the function code to 00000, the
previous user password is cleared and
password protection is disabled.
After the user password is set and takes effect,
you cannot enter the parameter menu if you
enter an incorrect password. Please remember
your password and save it in a secure place.
After you exit the function code editing interface,
the password protection function is enabled
within 1 minute. If password protection is
enabled, "0.0.0.0.0" is displayed when you
press the PRG/ESC key again to enter the
function code editing interface. You need to
enter the correct user password to enter the
interface.
Note: Restoring the default values may delete
the user password. Exercise caution when using
this function.
0
○
P07.01
Parameter copy
Used to set the parameter copy mode.
0: No operation
1: Upload parameters to the keypad
2: Download all parameters (including motor
parameters)
3: Download non-motor group parameters
4: Download motor group parameters
Note: After any operation among 1–4 is
0
◎