Inxpect SRE 200 Series - Page 87

LED Status
Inxpect Safety
application messages
Problem Solution
All LEDs Flashing green
one after the
other in
sequence
- The control unit is in
boot state.
Open the latest available
version of the Inxpect Safety
application, connect to the
device and proceed with the
automatic recovery
procedure.
If the issue persists, please
contact Technical Support.
All LEDs Off In Dashboard > System
status icons
Configuration not yet
applied to the
control unit.
Configure the system.
All LEDs Off Progress icon Configuration
transfer to the
control unit in
progress.
Wait for the transfer to be
completed.
Note: fault signal on the control unit (steady LED) takes priority over a faulty sensor signal. For the status of the
single sensor, check the sensor LED.
Note*: S1 is the first from the top.
Note**: S1 corresponds to the sensor with ID 1, S2 corresponds to the sensor with ID 2 and so on.
9.1.2 Sensor LED
Status
Inxpect Safety application
messages
Problem Solution
Steady
purple
- Sensor in boot state Contact Technical Support.
Flashing
purple *
- Sensor receiving a
firmware update
Wait for the update to be completed
without disconnecting the sensor.
Flashing
red. Two
flashes
followed by
a pause **
CANERROR Sensor without a valid
identifier assigned
Assign a Node ID to the sensor (see
"Connect the sensors to the control
unit" on page71).
Flashing
red. Three
flashes
followed by
a pause **
CANERROR Sensor does not receive
valid messages from
the control unit
Verify the connection of all the
sensors in the chain and check that
the number of sensors configured in
the Inxpect Safety application is equal
to the number of the sensors
physically connected
Flashing
red. Four
flashes
followed by
a pause **
SENSOR TEMPERATUREERROR
or SENSOR POWERERROR
Sensor in temperature
error or is receiving an
incorrect supply voltage
Check the sensor connection and that
the cable length is within the
maximum limits. Verify that the
temperature of the environment in
which the system is operating
conforms to the operating
temperatures listed in the technical
data in this manual.
9. Troubleshooting
Inxpect SRE 200 Series | Instruction manual v1.5 DEC 2023|Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
87