Inxpect SRE 200 Series

To Next Page

To Previous Page

9.2.8 Log file example

Event logs of ISC NID UP304 updated 2020/11/18 16:59:56

[Section 1 - Event logs]

380 2020/11/18 16:53:49 [ERROR] SENSOR#1 CANERROR (Disappearing)

375 2020/11/18 16:53:44 [ERROR] SENSOR#1 CANERROR (Code: 0x0010) COMMUNICATION LOST

356 2020/11/18 16:53:25 [INFO] CONTROLUNIT System configuration #16

30 2020/11/18 16:53:52 [ERROR] SENSOR#1 ACCELEROMETERERROR (Disappearing)

27 2020/11/18 16:47:56 [ERROR] SENSOR#1 ACCELEROMETERERROR (Code: 0x0010) TILTANGLEERROR

5 2020/11/18 16:47:30 [ERROR] SENSOR#1 SIGNALERROR (Code: 0x0012) MASKING

0 2020/11/18 16:47:25 [INFO] CONTROLUNIT Dynamic configuration #1

0 2020/11/18 16:47:25 [INFO] CONTROLUNIT System Boot #60

92 Rel. 0 d 00:01:32 [INFO] CONTROLUNIT Detection exit (field #2)

90 Rel. 0 d 00:01:30 [INFO] CONTROLUNIT Detection exit (field #1)

70 Rel. 0 d 00:01:10 [INFO] SENSOR#1 Detection access (field #2, 3100 mm/20°)

61 Rel. 0 d 00:01:01 [INFO] SENSOR#1 Detection access (field #1, 1200 mm/30°)

0 Rel. 0 d 00:00:00 [INFO] CONTROLUNIT Dynamic configuration #1

0 0 d 00:00:00 [INFO] CONTROLUNIT System Boot #61

[Section 2 - Diagnostic events log]

380 Rel. 0 d 00:06:20 [ERROR] SENSOR #1 CANERROR (Disappearing)

375 Rel. 0 d 00:06:15 [ERROR] SENSOR #1 CANERROR (Code: 0x0010) COMMUNICATION LOST

356 Rel. 0 d 00:05:56 [INFO] CONTROLUNIT System configuration #16

30 Rel. 0 d 00:00:30 [ERROR] SENSOR #1 ACCELEROMETERERROR (Disappearing)

27 Rel. 0 d 00:00:27 [ERROR] SENSOR #1 ACCELEROMETERERROR (Code: 0x0012) TILTANGLEERROR

5 Rel. 0 d 00:00:05 [ERROR] SENSOR #1 SIGNALERROR (Code: 0x0014) MASKING

9.2.9 Event list

The event logs are listed below:

Event Type

Diagnostic errors ERROR

System Boot INFO

System configuration INFO

Factory reset INFO

Stop signal INFO

Restart signal INFO

Detection access INFO

Detection exit INFO

Dynamic configuration in use INFO

Muting status INFO

Fieldbus connection INFO

9. Troubleshooting

Inxpect SRE 200 Series - Page 91