Digital Network Public Address & Voice Alarm System
Step 11: Click button which is on the right of "Close Partition", pop-up "partition selection" dialog box,
after finishing partition edit, the partition selected will also appear in the "closed partition" edit info box.
("Partition select" edit is the same as "partition selection" operation in "Step 10", while selected output
partition in "Step 10" won’t appear in the "closed partition" edit box).
Step 12: Click the "Host contact output" , then select button on the right, it will pop-up "contact
output" edit box, there is eight contacts configuration in the edit box, they are on behalf of eight input
contact configuration of the host rear panel: gray is disconnected, the green is connected.
Click button [OK] under the "contact output" edit box, then finish the contact output editing. Edited host
contact output status will be displayed in the edit box of "Host contact output".
Step 13: Click button [OK] under the edit box of "Add Task", then a task addition is finished. The newly
added task will appear in the task list. Select and click the newly added tasks, it will show the relevant
program content below the task list column.
To Next Page
Loading...
Need help?
General
