Digital Network Public Address & Voice Alarm System
Description:
In the "Equipment parameters configuration" dialog box, the configuration is divided into five categories:
1) zone/group configuration: configure the system zone and group number. (Zone number must be the
same with number of channels of zone amplifier, backup amplifier, otherwise the system will prompt the
zone configuration is wrong).
2) Global parameters configuration: configuration for all of the devices of the system module.
3) The host parameters configuration: related parameters configuration in the host system.
4) Zone amplifier parameters configuration: configure relevant parameters of zone amplifier.
5) Changeover parameters configuration: configure the related parameters of changeover.
Step 2: set up the system zone and group number, set or modify the system zone and group number in
the below edit box.
"zone number” is corresponding with actual area number, optional range is 1~255, here we choose "6"
(To illustrate the configurability of the system, here the VA-6000MS only used five main amplifier channel
number, in practical applications, it need to maximize system resources usage to save system cost).
For the "group quantity", group number in the range of: 1 ~ 255 are available, If users don't want to use
the default group, you can choose a number (range 1~255). Here we suggest the same number of zone
quantity or number over the quantity, depending on the actual demand, here we choose "10", as shown in
the above.
Note: the system default the current zone quantity is consistent with the user selected zone quantities.
To Next Page
Loading...
Need help?
General
