EasyManuals Logo

ITC VA-6000 Series User Manual

ITC VA-6000 Series
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
Digital Network Public Address & Voice Alarm System
- 84 -
Specification:
The smaller the value corresponding to the audio, the higher the priority, that means When different audio
output simultaneously to the same zone, the high-priority audio output will output firstly, if high-priority
audio output cut lower priority audio output, after the high-priority audio stopped outputting, lower-priority
audio will recover outputting automatically(except EVAC and ALEART). For the same priority of audio,
keeping the output state of the last operation.
When the controller of VA-6000MA is in emergency broadcasting, audio 1 can be synchronized from the
controller VA-6000MA "Record Out" audio output terminal for easy external recording device.
Note: The audio system priority level, We generally recommend to use the system default value.
3) Controller System Configuration password: Set password to enter VA-6000MA "System Settings"
menu, A length of 6 numbers, factory-set default login password is: 666666.
4) Remote Phone Control Password: Set remote telephone login password of entry system, the length
is four numbers, the factory settings default login password is: 6666.
5) Help Switch: When an emergency occurs, the system will be configured requirements, whether to
automatically dial a preset phone number.
6) Help Calls: When the emergency occurs, in case of the above help switch turned on, the system will
call out for help according to default preset phone numbers.
7) Chargers temperature display mode: Users can choose "Celsius" or "Fahrenheit" display mode.
8) Minimum / maximum operating temperature: Configuring charger temperature range the charger's
operating temperature range can be set: -30 to 80. (If you don’t configure the VA-6000BC,Use UPS <By
controller configuration Select> or no backup power,This step can be omitted, and if no special
requirements, the charger can keep the default parameters)
Step 4: Configure the controller operating parameters, click the "Controller Configuration" label, the
pop-up "Controller Configuration" list box, as shown below:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITC VA-6000 Series and is the answer not in the manual?

ITC VA-6000 Series Specifications

General IconGeneral
BrandITC
ModelVA-6000 Series
CategorySecurity System
LanguageEnglish

Related product manuals