Digital Network Public Address & Voice Alarm System
5) The starting point of the zone amplifier audio signal configuration:
According to user requirements, configure the local audio EMIC / GMIC / LINE1 / LINE2 detectable
signal range levels: 0 ~ 10 levels.
6) Zone MAC address configuration:
MAC: You can change or add zone amplifier MAC physical address. Click on "..." behind of the zone
amplifier's MAC address, it will pop up zone amplifier "MAC Configuration" list box; select the MAC
address inside of the list box, and then click "OK" to change the zone amplifier MAC address; if you need
to add the new MAC address, click the "Add" button, then write new MAC address in the pop-up box, and
then click "OK" to add a new MAC address, the new MAC address will be in the MAC configuration list
box. (Detailed configuration, refers to the "Controller MAC Address Configuration")
Step 6: The changeover parameters configuration:
Click the "changeover parameters configuration" tab, can pop-up "changeover parameters configuration"
drop-down list box.
1) Quantity configurations:
Click the "quantity Configuration" tab in left of the "changeover parameters configuration" window, click to
select the numbers inside of the list box, you can configure the number of changeover, the system allows
you to configure the maximum number is: 64.
(2) Changeover’s main and standby amplifier channel configuration:
1. The main amplifier channels: used to configure the number of changeover main amplifier channel, 1
channel represents 1 physical zone, each changeover can be configured with 8 physical zones at max,
only configured zones will occupy the current physical zones, If no, the current physical zone will not be
used, the main amplifier channels configurable number: 1-8.
2. Standby amplifier channels: according to user requirements, whether configure changeover with
To Next Page
Loading...
Need help?
General
