ITech IT-M7700 Series - Page 116

156 pages

To Next Page

To Previous Page

Multi-units operation

3. Through the PC software, send SCPI commands to control the specified

instrument or all instruments on the line. For details, see the content of the

multi-channel command chapter of "IT-M7700 Programming Guide".

105

Main Page

Warranty3
Limitation of Warranty3
Safety Symbols4
Safety Precautions4
Environmental Conditions6
Regulation Tag7
Waste Electrical and Electronic Equipment (WEEE) Directive8
Compliance Information9
Table of Contents10
Quick Reference12
Brief Introduction12
Front Panel at a Glance13
Front Panel Keys at a Glance15
Rear Panel at a Glance17
Front Panel Display at a Glance19
Configuration Menu at a Glance21
System Menu at a Glance24
Optional Accessories28
Inspection and Installation31
Verifying the Shipment31
Instrument Size Introduction32
Connecting the Power Cord34
Connecting the Device under Test (DUT)37
Connecting the Interface40
USB Interface41
GPIB Interface42
LAN Interface42
Interface48
CAN Interface50
Interface52
Getting Started54
Power-On the Instrument54
Applying DC Output56
Applying Waveform Output57
Operation and Application60
Select the Output Mode60
Setting the Voltage Output Range61
Set the AC Output62
Set the AC Voltage62
Set the AC Frequency63
Set the AC Phase Angle63
Select the Output Waveform64
Set the DC Output65
Set the DC Voltage65
Set the DC Voltage Rise Time65
Set the Over-Current Protection Point66
Turning the Output on and off67
Step or Continue Output67
Executing Measurement68
Measurement Functions69
Function Operation70
Function Menu at a Glance70
List Function73
Dimmer Function75
Surge/Trap Function76
Digital I/O Function78
Set the Output Timer Function82
Protection Function82
Set the Over-Voltage Protection (Rms)82
Set the Over-Voltage Protection (Peak)83
Set the Under-Voltage Protection (Rms)84
Set the Over-Current Protection (Rms)84
Set the Over-Current Protection (Peak)86
Set the Over-Power Protection87
Set the Current Limiting Protection87
Set the Sense Check Protection88
Limiting the Setting Value Range89
System-Related Operations90
Switch Local/Remote Mode90
Save and Recall Operations90
Key Lock Function91
Set the Beeper Status91
Set the Power-On State91
Restore the As-Shipped Settings92
View the System Information96
Set the Relay Control97
External Analog Quantity Function (Option)98
Definition of Analog Interface98
Enable/Disable Analog Control100
Analog Quantity Control101
Calibrate External Voltage Control105
Multi-Units Operation107
Series Operation107
Three-Phase Operation110
Multi-Channel Function114
Routine Maintenance117
Instrument Self-Test117
Cleaning and Maintenance117
Prompt Information Reference118
Contact of ITECH Engineers119
Return for Repair121
Technical Specification122
M7721122
M7721L124
M7722126
M7722D129
M7722E131
M7722L133
M7723135
M7723D138
M7723E140
A Appendix143
Specifications of Red and Black Test Cables143
Built -In Waveforms144

ITech IT-M7700 Series - Page 116

Table of Contents

Other manuals for ITech IT-M7700 Series

Related product manuals