Getting Started
3 Getting Started
Before learning the details of IT-M7700, let us briefly cover the use of the IT-
M7700.
♦ Power-on the Instrument
♦ Applying DC Output
♦ Applying Waveform Output
3.1 Power-on the Instrument
Precautions
To prevent electric shock and damage to the instrument, observe the following
precautions.
• Before connecting power cord, be sure to confirm that the power
voltage matches with the supply voltage.
• Be sure to connect the main power socket to the power outlet with
protective grounding. Do not use terminal board without protective
grounding. Before operation, be sure that the instrument is well
grounded.
• Ensure that the output electrodes are either insulated or covered
using the safety covers provided, so that no accidental contact with
lethal voltages can occur.
• If you notice strange sounds, unusual odors, fire, or smoke around
or from inside the instrument, flip the POWER switch to the (O) side
to turn the instrument off, or remove the power cord plug from the
outlet. The detachable power cord may be used as an emergency
disconnecting device. Removing the power cord will disconnect
AC input power to the unit.
Power Switch Introduction
The power switch is located in the lower left corner of the front panel. See 1.2
Front Panel at a Glance for details. The power switch is a push button. Press
the button once to turn the instrument on and press it again to turn the instru-
ment off.
Copyright © Itech Electronic Co., Ltd.
43
To Next Page
Loading...
Need help?
General
