Operation and Application
4 Operation and Application
This chapter describes the operation and application of the instrument in
details.
♦ Select the Output Mode
♦ Setting the Voltage Output Range
♦ Set the AC Output
♦ Set the DC Output
♦ Set the Over-current Protection Point
♦ Turning the Output On and Off
♦ Step or Continue Output
♦ Executing Measurement
♦ Function Operation
♦ Protection Function
♦ System-Related Operations
♦ External Analog Quantity Function (Option)
4.1 Select the Output Mode
The IT-M7700 series power supply has 3 output modes: AC, DC and AC+DC.
The User should set specific output mode based on required applications.
AC Mode
This mode is the default mode when the instrument is powered on (It is neces-
sary to press [AC] key to switch the DC mode back to the AC mode), indicating
that the instrument is used as AC power supply. Under this mode, the instru-
ment will generate AC output.
Please refer to 4.3 Set the AC Output for the setting of related output parame-
ters of the instrument under AC mode.
DC Mode
Press [DC] key on the front panel to switch the instrument from AC mode to DC
mode. At this moment, the instrument serves as a DC power supply. Under this
mode, the instrument will generate DC output.
Please refer to 4.4 Set the DC Output for the setting of related output parame-
ters of the instrument under DC mode.
Copyright © Itech Electronic Co., Ltd.
49