ITech IT-M7700 Series User Manual

Operation and Application
1. Press the composite keys [Shift] + [V-set](Config) to enter into the configu-
ration menu interface.
2. Rotate the knob to select V-Rise Time and press [Enter] key to confirm.
3. Use left and right keys and rotate the knob to set the voltage rise time. Press
[Enter] key to confirm.
4. Press [Esc] to exit the configuration menu setting.
4.5 Set the Over-current Protection Point
With this instrument, you can directly set the over-current protection point value
for the OCP (rms) function through the [I-set] key. Refer to 4.10.5 Set the Over-
Current Protection (peak) for the related description of OCP (rms).
The setting range of over-current protection point value is between 0A and full-
scale rated output current, which is limited by OCP-Max and OCP-Min, i.e., the
over-current protection point value should not be higher than OCP-Max and not
lower than OCP-Min. Please refer to 4.10.9 Limiting the Setting Value Range for
the setting of OCP-Max and OCP-Min.
To set OCPrms, refer to the steps below:
1. Press [I-set] key to position the cursor to the OCPrms setting value.
Meanwhile, the [I-set] key will light up.
50.0V 6.00A 60.0Hz
0.00W 0.00Ip 0.00PF
2. Rotate the knob clockwise to increase the OCPrms setting value and
anticlockwise to decrease the value. Set the required value.
The knob can be used together with the left/right navigation keys. Press the
left/right navigation keys to move the cursor to a digit. Rotate the knob to
change the digit value.
3. Press [Enter] key to confirm the OCPrms setting value.
Press [Esc] key to exit the input mode.
Copyright © Itech Electronic Co., Ltd.
55

ITech IT-M7700 Series Specifications

General

Brand	ITech
Model	IT-M7700 Series
Category	Portable Generator
Language	English