36
JAKA Zu MiniCab v1.1
Make sure there
is no breakage or
damage
Joint loosing
Visual
inspection
Tightening
If the cable is
obviously
broken, please
replace it
(Note) Wipe the dust with a soft cloth when cleaning. Do not use the blower or other equipment to blow
away the dust.
7.3 Replacement and Preservation of Components
When changing the parts of the robot control device, please comply with the following precautions for safe
operation.
1、 Any modification of our products is strictly prohibited.
2、 Fire, malfunctions, and incorrect actions due to modification may result in
personal injury or damage to machines.
3、 Any loss caused by the modification of our products will not be covered by our
warranty.
1、 In order to prevent electric shock, please close the circuit breaker in advance
and cut off the main power supply when replacing components.
1. Please replace the parts after cutting off the main power supply for 5 minutes.
2. There is a risk of electric shock due to the residual charge in the substrate
and electrolytic capacitor.
3. Do not work with wet hands.
4. When electric shock occurs, it will cause serious injury or death.
1. Replacement operations shall be carried out by designated operators.
2. Electric shock or accidental clamping of a robot will result in serious injury or
death.
1. There are a large number of connection interfaces between the printing
substrates. Be cautious when replacing parts to avoid incorrect or missing
insertion.
2. If electric shock and fire occurs, it will cause serious injury or death.
1. When replacing, do not damage the wiring or pull the interface to damage it..
2. When replacing, do not touch the electronic parts of the printed substrate and
the contact parts of the circuit and interface. Hold the edge of the printing
substrate.
3. If touched carelessly, it could cause an electric shock that could lead to
serious injury or death.
To Next Page
Loading...
