NOTE
If you are not connecting a safety device, connect the I/O-S connector with the two lead wires
short-circuited.
11.2 Pin Nos. (Robot Side)
Connector type: SRCN6A13-3P (Manufactured by Japan Aviation Electronics Industry, Ltd.)
The I/O-S connector attachment is included for connecting a safety device, such as an area
sensor, to the robot. Correctly connect the lead wires from the safety device to the I/O-S connector.
For further information, refer to “11.3 Safety Device” and the safety device’s instruction manual.
Caution
A person entering the operating range of the robot may be injured.
Install an area sensor (etc.) interlock using the I/O-S connector and
maintain safety precautions at all times.
75
To Next Page
Loading...
