M4 screw holes (8)
Two vertical M4 nut
T-slots (3 sides)
JR3200 Series
NOTE
Refer to “4. External Dimensions” for the dimensions of the M4 screw holes and the M4 nut T-slots.
Example: JR3203N-AC
6. ATTACHING EQUIPMENT
When you want to attach a feeder, tool controller or jig to your robot, there are M4 nut T-slots on the
column, and M4 screw holes (JR3200: 8, JR3300: 20, JR3400: 16 screws) on the base which you can
use, as shown in the illustrations below.
Refer to “4. External Dimensions” for attaching dimensions.
46
To Next Page
Loading...
