QUANTUM™ HD COMPRESSOR CONTROL PANEL
OPERATION
090.040-O (MAR 12)
Page 122
CONFIGURATION
Retransmitting Outputs
ACCESSING:
A - H
Retransmitting Outputs
DESCRIPTION: The Retransmit Output screens (A-H and
I-P) are used to view and set the analog input assign-
ments, when it is desirable to use the retransmit feature.
Both screens consists of the same layout, with the excep-
tion of the Input Channel name:
Input Channel (to Retransmit) - Use this pull down
menu for each channel to select the analog signal
that you would like to retransmit:
• Capacity Slide Position
• Volume Slide Position
• Suction Pressure
• Discharge Pressure
• Compressor Oil Pressure
• Main Oil Injection Pressure
• Economizer Pressure
• Filter Pressure
• Intermediate Pressure
• Balance Piston Pressure
• System Discharge Pressure
• Suction Temperature
• Discharge Temperature
• Compressor Oil Temperature
• Oil Separator Temperature
• Process/Brine Temperature Leaving
• Process/Brine Temperature Entering
• Remote Control Setpoint
• Motor Current
• RPM
• Auxiliary Analog #1 - #20
• Manifold Pressure
• Remote Capacity Position
• Compressor Vibration – Suction
• Compressor Vibration – Discharge
• Motor Vibration – Shaft Side
• Motor Vibration – Opposite Shaft Side
• Motor Temperature – Shaft Side
• Motor Temperature – Opposite Shaft Side
• Motor Stator #1 - #3
• Vyper Coolant Temperature
Input Value - This will show the analog value that is
being received for a particular channel.
Output Value - This will show the analog value that
is being sent from a particular channel.
IO Board - Use this pull down menu to select the
source of the retransmit signal:
• None
• Analog Board 1
• Analog Board 2
I/O Channel - This will show the Output channel
(with regard to the I/O Board selection) that the re-
transmit function will be assigned to.
To Next Page
