QUANTUM™ HD COMPRESSOR CONTROL PANEL
OPERATION
090.040-O (MAR 12)
Page 87
DESCRIPTION: Scheduling allows the user to program up
to four different operating schedules for each day of the
week. This can be a great way to save energy. At night
or on weekends and holidays, or even over lunch periods
when room doors are kept closed or production is mini-
mized, a higher temperature can be set to reduce energy
consumption.
CAPACITY MODE SCHEDULING
This screen shows a time schedule. Up to four
different modes can be entered for each day of
the week.
Notice that there are four columns of Hour/Min-
ute entries, each followed by a Mode (1 - 4). Use
the left most column (on the row for the day of
the week that you wish to schedule) to enter the
time of day that you would like the compressor
to switch form it’s normal operating mode, into
the scheduled mode. When that time of day ar-
rives, whatever mode the compressor WAS run-
ning in, will be switched over to the scheduled
(Mode 1 -4) mode. This mode will then be the
active running mode, and will continue to be the
active mode until the time in the following col-
umn is reached. If the time in the next column is
00:00, it will be skipped.
The Schedule must be activated to switch the
presently active Mode to the Scheduling mode
at the assigned time. An entry of 00:00 will void
the time entry fi eld. If setback is required at mid-
night (00:00) use 00:01.
The following are descriptions of the setpoints:
Time Column - The time of day that you
want to switch to the Scheduled regulation
setpoints of the active capacity control.
Mode Column - Set this to the Mode (1 - 4)
that you want to run at the assigned time.
Capacity Control
CONFIGURATION
Capacity Control - Mode Scheduling
ACCESSING:
Mode Schedules
To Next Page
Loading...
