EasyManua.ls Logo

Johnson Controls FRICK QUANTUM HD - Operating Display Screens; Home

Johnson Controls FRICK QUANTUM HD
160 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
QUANTUM™ HD COMPRESSOR CONTROL PANEL
OPERATION
090.040-O (MAR 12)
Page 15
DESCRIPTION: This is the default screen (also called the
Home screen). Once the Quantum™ HD has booted, this
screen will appear. The most important information about
the compressor and the applicable subsystems operation
is displayed here. The Operating Status screen is continu-
ously updated and provides a variety of information with
regard to the current condition and performance of the
compressor unit and subsystem This screen is divided into
ve sections:
HEADER - The Header area appears at the very top of
the screen and is common to all screens. Each screen
Header provides the same information, as well as a
method of accessing additional screens. The infor-
mation and access features appear here:
Normal/Warning/Shutdown Status Bar - If
either a Warning or Shutdown condition is en-
countered, it will be noti ed with white text on
a red background in the upper left corner of the
Header, as shown on the screen above. If there
are no warnings or shutdowns, this area will dis-
play Normal in white text on a green background.
To view what Warnings or Shutdowns are active,
press the [Alarms] icon.
The de nitions for the two messages are:
Warning - A message appears when a
warning is present. The message indicates
that a warning setpoint has been reached,
or exceeded, and requires operator ac-
knowledgement - but allows the compres-
sor to continue to run if it is already running.
Shutdown - A message appears when a
shutdown has occurred. The message in-
dicates that a shutdown setpoint has been
reached, or exceeded, and requires an
operator to acknowledge, and causes the
compressor to shut down.
Panel Name - If a customized panel name has
been entered for the panel, it will appear at the
very top center of the Header. To change the
Panel Name, perform the following icon selec-
tions:
Select the [Menu] icon > [Con guration] >
[Compressor].
The Compressor screen will now be shown. In
the box that is entitled Compressor Info, is a line
called Compressor Name. To the right of Com-
SECTION 3
OPERATING DISPLAY SCREENS
ACCESSING:

Table of Contents

Other manuals for Johnson Controls FRICK QUANTUM HD

Related product manuals