QUANTUM™ HD COMPRESSOR CONTROL PANEL
OPERATION
090.040-O (MAR 12)
Page 42
DESCRIPTION: This screen allows for certain specifi c set-
points to be adjusted. The following information is shown
on this screen:
CHANNEL CONFIGURATION - This information is
set using the Confi guration > Proportional / Integral
screen.
[Name] - The name of the control channel is
shown here.
[Control Input] - One of the following channels
will be shown here:
• Capacity Slide Position
• Volume Slide Position
• Suction Pressure
• Discharge Pressure
• Compressor Oil Pressure
• Main Oil Injection Pressure
• Economizer Pressure
• Filter Pressure
• Intermediate Pressure
• Balance Piston Pressure
• System Discharge Pressure
• Suction Temperature
• Discharge Temperature
• Compressor Oil Temperature
• Oil Separator Temperature
• Process/Brine Temperature Leaving
• Process/Brine Temperature Entering
• Remote Control Setpoint
• Motor Current
• RPM
• Kilowatts
• User defi ned analog inputs #1 - #10
• EZ Cool Feedback %
• User defi ned analog inputs #12 - #20
• Manifold Pressure
• Remote Capacity Position
• Compressor Vibration – Suction
• Compressor Vibration – Discharge
• Motor Vibration – Shaft Side
• Motor Vibration – Opposite Shaft Side
• Motor Temperature – Shaft Side
• Motor Temperature – Opposite Shaft
Side
• Motor Stator #1 - #3•
[Control] - One of the following control options
will be shown:
• Disabled - No PID control.
• Running - PID Control only controls
when the compressor is running.
• Active - PID control always active.
CONTROL SETPOINTS
PI Control
ACCESSING:
PI Control PI Control 2
To Next Page
