SM-18006
i
Refer to the Engineering Manual for details of operation limitations.
Important Notice
● Johnson Controls Inc. pursues a policy of continuing improvement in design and performance in its products.
As such, Johnson Controls Inc. reserves the right to make changes at any time without prior notice.
● Johnson Controls Inc. cannot anticipate every possible circumstance that might involve a potential hazard.
● This heat pump and heat recovery air conditioning unit is designed for standard air conditioning
applications only.
Do not use this unit for anything other than the purposes for which it was intended for.
● The installer and system specialist shall safeguard against leakage in accordance with local codes.
No part of this manual may be reproduced in any way without the expressed written consent of Johnson
Controls Inc.
● This heat pump and heat recovery air conditioning unit will be operated and serviced in the United States
of America and comes with a full complement of the appropriate Safety, Danger, and Caution, Warnings.
● If you have questions, please contact your distributor or contractor.
● This manual provides common descriptions, basic and advanced information to maintain and service this
heat pump and heat recovery air conditioning unit which you operate as well for other models.
● This heat pump and heat recovery air conditioning unit is designed for a specic temperature range. For
optimum performance and long life, operate this unit within the range limits according to the table below.
● This manual should be considered as a permanent part of the air conditioning equipment and should
remain with the air conditioning equipment.
Temperature
Indoor Unit
Inlet Air Temperature
Cooling Operation Range °F WB (°C WB) 59 (15) ~ 73 (23)
Heating Operation Range °F DB (°C DB) 59 (15) ~ 80 (27)
Water Source Unit Entering Water Temperature °F (°C) 50 (10) ~ 113 (45)
DB: Dry Bulb, WB: Wet Bulb
To Next Page