3-14
SM-18006
TROUBLESHOOTING
No. Item Data Name No. Item Data Name
1 b1 Set Temp. 22 H2 Suction Pressure
2 b2 Inlet Air Temp. 23 H3 Control Information
3 b3 Discharge Air Temp. 24 H4 Operating Frequency
4 b4 Liquid Pipe Temp. 25 J1 I.U. Capacity
5 b5 Remote Thermistor Temp. 26 J2 O.U. Code
6 b6 Entering Water Temp. 27 J3 System Number (1)
7 b7 Gas Pipe Temp. 28 J4 System Number (2)
8 b8 Evaporating Temp. at Heating 29 L1 I.U. Expansion Valve
9 b9 Number of Operating Compressors 30 L2 W.S. Expansion Valve 1
10 bA Comp. Top Temp. 31 L3 W.S. Expansion Valve 2
11 bb Thermo Temp. of Wired Controller 32 L4 W.S. Expansion Valve B
12 bC Not Prepared 33 P1 Comp. Current
13 C1 I.U. Micro-Computer 34 P2 Comp. Operating Accumulated Time
14 C2 W.S. Micro-Computer 35 q1 Motion Sensor Reaction Rate *
1
15 d1 Stopping Cause State Indication 36 q2 Radiation Sensor Temp. *
1
16 E1 Times of Abnormality 37 q3 Motion Sensor 1 Reaction Rate *
1
17 E2 Times of Power Failure 38 q4 Motion Sensor 2 Reaction Rate *
1
18 E3 Times of Abnormal Transmitting 39 q5 Motion Sensor 3 Reaction Rate *
1
19 E4 Times of Inverter Tripping 40 q6 Motion Sensor 4 Reaction Rate *
1
20 F1 Louver Sensor State 41 q7 Setting Temp. Collected Value
21 H1 Discharge Pressure
Features of Check Mode 1
No. Item Data Name No. Item Data Name
1 q1 Inlet Air Temp. 9 q9 Discharge Pressure
2 q2 Discharge Air Temp. 10 qA Suction Pressure
3 q3 Liquid Pipe Temp. 11 qb Control Information
4 q4 Entering Water Temp. 12 qC Operating Frequency
5 q5 Gas Pipe Temp. 13 qd I.U. Expansion Valve
6 q6 Evaporating Temp. at Heating 14 qE W.S. Expansion Valve 1
7 q7 Number of Operating Compressors 15 qF Comp. Current
8 q8 Comp. Top Temp.
Features of Check Mode 2
*
1
The average value for 30 seconds (update cycle
time of Check Mode) is displayed on the LCD.
To Next Page