Johnson Controls Tyco PowerSeries Pro HS3032 - Page 50

Hereby, Tyco Safety Products Canada Ltd declares that the radio equipment type is in compliance
with Directive 2014/53/EU. The full text of the EU declarations of conformity for the models
mentioned below are available at the following internet addresses:
HS2LCDPRO: http://dsc.com/pdf/1903004
HS2TCHPRO(BLK): http://dsc.com/pdf/1903007
HS2LCDRFPRO4: http://dsc.com/pdf/1903008
HS2LCDRFPRO8: http://dsc.com/pdf/1903005
HS2LCDWF(V)PRO8: http://dsc.com/pdf/1903009
HS2LCDWF(V)PRO4: http://dsc.com/pdf/1903007
Frequency Band / Maximum Power
433.22MHz – 434.62MHz/10mW
868.0MHz – 868.6MHz/10mW
868.7MHz – 869.2MHz/10mW
119MHz – 135MHz - 66 dbµA/m @10m
European single point of contact: Tyco Safety Products, Voltaweg 20, 6101 XK Echt, Netherlands
UK Compliance Statement
In the UK this product is suitable for use in systems installed to conform to PD 6662:2017 at Grade 3
and environmental class II with the following notification options: A, B, C, D, E.
Where HS3032, HS3128, and HS3248 are used with a single path signaling method (such as the
Integrated Digital Dialer), please note the following limitation:
Important
Your attention is drawn to the fact that failure or compromise of single path signaling cannot be
passed to the police. While the failure persists, subsequent alarms cannot be notified to the alarm
receiving centre and passed to the police.
Setting Methods
The HS3032, HS3128, and HS3248 are capable of supporting the completion of the full setting
procedure by the following methods:
a) push button switch, mounted outside the supervised premises; or b) protective switch (i.e., door
contact) fitted to the final exit door of the alarmed premises or area. The setting procedure is a
two-stage process of initiating the setting procedure within the supervised premises (e.g., using
Mini Prox Tag (MPT) or user code) followed by completion of setting by one of the two methods
mentioned above. Please check with the Installer which method has been enabled for your system.
Unsetting Methods
The HS3032, HS3128, and HS3248 are capable of supporting the following unsetting methods in
accordance with BS8243:
6.4.2 Prevention of entry to the supervised premises before the alarm system is unset. Unsetting
using remote key before entering the supervised premises causes or permits the initial entry door
to be unlocked.
6.4.5 Completion of unsetting using a digital key (e.g., MPT or PG8929, PG8939, PG8949) either
before entering the protected premises (use PG8929, PG8939, PG8949) or after entering the
protected premises (use MPT). The entry delay is activated if the initial entry door is opened before
the HS3032, HS3128, HS3248 has been unset. During the entry time, it is possible to unset the alarm
system using a digital key only. Complete unsetting before programmed entry delay expires.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual50