JRC JMR-7210-6X - 18.6 Setting Radar Antennas

18-15 Section 18 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
18.6 Setting Radar Antennas
Select [TXRX] in the classification pane.
Set radar antennas in the setting dialog of the edit pane (RADAR screen only).
18.6.1 Setting radar antennas
Set radar antennas.
Setting Item Description of Setting Setting Value
PRF Fine
Tuning
You can reduce the setting value of the repetition
transmission frequency by 0.2% (maximum value is 0).
0 to 31
Stagger
Trigger
Select On/Off of the Radio Wave Interference Reduction
function.
It is not displayed when a solid state radar antenna is
connected. The previous setting value is maintained,
however.
To enable: Select.
To disable: Clear.
PRF Set up the operation mode of the transmitter's repetition
transmission frequency.
[Economy] is not displayed when a S-band solid state radar
antenna is connected. If a S-band solid state radar antenna is
connected while an operation mode is being specified, the
setting will be reset to the default value.
[Economy] and [HighPower] is not displayed when a X-band
solid state radar antenna is connected. If a X-band solid state
radar antenna is connected while an operation mode is being
specified, the setting will be reset to the default value.
Normal
Economy
High Power
Ice Class
Standby Mode
Turn On/Off the Ice Class Standby mode. To enable: Select.
To disable: Clear.