JRC NCR-333 - Character Size Setting (CHARACTER SIZE); CER Setting (CER DISP.SETTING)

I 6.3.4.1 Character size setting (CHARACTER SIZE)
Displayed character can be changed into three sizes.
Select , and press the lEN] key. Cursor moves to the right side of ":R.
Press the • ..-key, and then press the IENlj key.
If the EN key is pressed, the selected character size is saved, and the displayed character is changed.
l
, //
/{ / cHARAcfliR / si'zE /// : '/ NoRMAL // /I
/ / // // / // // / // / // / // / // / //////// /
' ' . ' ' . ' ' . ' ' . ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' ' . '
The initial setting is "NORMAlw.
NORMAL: The normal character size: 13x9 dots
MEDIUM: The medium character size: 16x9 dots
LARGE: The large character size: 20x16 dots
I 6.3.4.2 CER setting (CER DISP .SETTING)
A AA A AA A AA A AA AA A AA A AA A AA A AA A AA AA A A /
I 2. CER DISP. SETTING : ON I
" A A A A A ~c~~ A : ,9!i!\R!',9ATAEARA AEARARPARA ARAAATA E) A A,
The initial setting is "OFF".
ON: "CER• is displayed on the end of message.
OFF: "CER• is not displayed.
r1>: Character Error Rate
(When CER DISP.SETTING is set MaN·)
(When CER DISP.SETTING is set "OFF")
6-44