JRC NCR-333 - 5.1.2 Mounting

I 5.1.2 Mounting
Mount the NCR-333 on a table top, a bulkhead, or a ceiling by using the mounting base. Opening the case
is not necessary for mounting.
And keep a clearance for the maintenance (refer to figure below).
The mounting procedure is as follows;
Loose the two knobs to remove the mounting base.
Mount the mounting base on the selected location.
Install the case on the mounting base by securing the two knobs.
5-2
0
Ll'"'l
370 min
21.2 196 21.2
f--
I I
...
0
0
1--
\ 1.--65
MOUNTING BASE (BOTTOM VIEW)
'/
CLEARANCE
Space required for receiver installation
190 min
Wall
/"
(Unit: mm)